LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1994 >> C220 >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Steering - 140 Chassis) >> Testing & Repair >> Removing and installing steering angle sensor - AR46.10-P-0300 >> Removing and installing steering angle sensor - AR46.10-P-0300A >> Activating steering angle sensor - AR46.10-P-0300-01A

Activating steering angle sensor - AR46.10-P-0300-01A

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT

If the battery is disconnected or the power supply to the steering angle sensor is interrupted the ADS or ESP control module switches to malfunction.

The ADS or ESP malfunction indicator lamp (A1e27 or A1e42) come on.

It is necessary to reactivate the steering angle sensor to eliminate the malfunction.

Activating steering angle sensor 

  1. Start engine and allow to idle.
  2. Turn steering wheel from lock to lock

The ADS or ESP malfunction indicator lamp (A1e27 or A1e42) should go out.

Fig 1: Identifying ABS, EPS & EPC Malfunction Indicator Lamp
G04607484Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Fig 2: Identifying ADS Or ESP Malfunction Indicator Lamp
G04607485Courtesy of MERCEDES-BENZ OF NORTH AMERICA.