LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1994 >> C220 >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Steering - 140 Chassis) >> Testing & Repair >> Dismantling and assembling electrically adjustable jacket tube - AR46.10-P-0600A >> Removing and installing lower bracket for jacket tube - AR46.10-P-0600-02A

Removing and installing lower bracket for jacket tube - AR46.10-P-0600-02A

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

REMOVINGRemoval 

  1. Loosen screws (82a) and remove bracket (82).
  2. Remove conical rings (82b).

    INSTALLINGInstallation 

  3. Install conical rings (82b) in the outer jacket tube.
  4. Attach bracket (82) with spigot towards the engine.
  5. By alternately tightening the screws (82a) in the conical rings (82b) secure the bracket.

    NOTES

    The bracket must be mounted on the jacket tube centrally and without any play. In order to ensure satisfactory height adjustment of the steering wheel, it must be possible to tilt the bracket against a slight friction torque (approx. 0.5 Nm).

    Fig 1: Identifying Jacket Tube Lower Bracket Components
    G04685927Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
scientia non olet · About LEMON Manuals