Checking and adjusting installed position of upper wishbone related to bearing shell - AR33.20-P-0500-02A
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
TEST VALUES OF WHEEL LOCATION SYSTEM, HUB
| Number | Designation | Model 140 | ||
|---|---|---|---|---|
| BE33.20-P-1001-01A | Test dimension "A" for adjusting the upper wishbone in the bearing shell | mm | 63 | |
| Refer to illustration | &.2. (AR33.20-P-0500-02A ) | |||
| Number | Designation | Model 140 | |
|---|---|---|---|
| BA33.20-P-1008-01A | Self-locking nut of upper wishbone in bearing shell | Nm | 120 |
The bearing shell (6a) is screwed onto the upper wishbone (6) in a defined position (refer to table for dimension A). If there is a difference, adjust the angle of inclination of the upper wishbone.
- Loosen self-locking nut (6e).
- Adjust the inclination of the upper wishbone in accordance with test dimension "A".
- Tighten self-locking nut (6e) to the specified
.