Adjustment of the engine stop - ra22006010220x(0220)
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
Engines 601, 602 (except 602.98), 603
Preceding work:
Bottom engine compartment lining removed (01-006).
Operation no. of operation texts and operation values or standard texts and flat rates; 22-2111
|
NOTE:
For this adjustment, the vehicle must be standing on its wheels ready for the road. The engine stop must not be treated with oil or grease.
|
|
| Adjusting bolt (1) | slacken at front engine stop, tighten, 130 Nm insert gauge 201 589 04 23 00 remove (steps 1, 3 - 7).
NOTE:
Slacken prepared engine stop from frame cross member.
|
| Adjusting screw (11) | slacken at rear engine mount, tighten, 30 Nm (steps 2, 5). |
| Tightening torques | Nm |
|---|---|
| Adjusting bolt, front engine stop | 130 |
| Adjusting screw, rear engine mount | 30 |
Special tools
NOTE:
To adjust the engine stop, the vehicle must be ready for the road and be standing on its wheels. The engine stop must not be treated with oil or grease.
- Slacken adjusting bolt (1) at engine stop (2) fully.NOTE: Slacken engine stop which is sticking to frame cross member as a result of wax or paint.
04 Gauge 201 589 04 23 00
- Slacken adjusting screw (11) at rear engine supporting bracket fully.
- Insert gauge 201 589 04 23 00 (02) at engine stop.
- Move engine by shaking slightly from left to right by hand.
- Tighten adjusting screw at rear engine mount, 30 Nm.
- Tighten adjusting bolt (1) at engine stop (2), 130 Nm.
- Remove gauge (02).