LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1994 >> C220 >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Propeller Shaft - 140 Chassis) >> Testing & Repair >> Remove/install propeller shaft - AR41.10-P-0050DA >> Connect sections of propeller shaft Long-life grease (NLGI grade 2) - AR41.10-P-0050-05DA

Connect sections of propeller shaft Long-life grease (NLGI grade 2) - AR41.10-P-0050-05DA

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
  1. Coat the splined profile with Molykote grease before assembly.
  2. Reconnect front and rear sections of propeller shaft. The humps on the front propeller shaft must be between the two humps on the linkage arm (arrows).

    IMPORTANT Ensure correct seat of rubber sleeve at large diameter.

    Fig 1: Identifying Humps On Linkage Arm (Propeller Shaft Without Clamp)
    G04715521Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
    Fig 2: Identifying Humps On Linkage Arm (Propeller Shaft With Clamp)
    G04715522Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
scientia non olet · About LEMON Manuals