Removing and installing throttle control cable - AR30.10-P-3400F
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 120.980 /981
| Removal, installation | |||
| 1 | Remove guide (30/5) | First pull plastic nipple out of guide |
|
| 2 | Unhook control cable (30) from transfer lever (6) | ||
| 3 | Press plastic clip (30/4) together and remove from fixed lever (10) together with control cable | ||
| 4 | Remove cover below instrument panel | ||
| 5 | Unhook control cable mount (arrow) from accelerator pedal lever (33) | For this purpose, pull out holder with spreading pin (37) | |
| 6 | Push control cable (30) toward exterior from passenger compartment | ||
| 7 | Completely remove control cable (30) from engine compartment | For this purpose: ↓ On model 140 Remove air collection housing, reinstall. See Repair instructions for automatic heater, model 140, Operation no. 83-140 |
|
| 6 | Reinstall in opposite order | ||
| 7 | Lubricate control cable (30) between guide (30/5) and end element with corrosion protection grease | *BR00.45-Z-1006-06A | |
| 8 | Check control, adjust | AR30.10-P-1010F |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1006-06A | Grease | A 001 989 37 51 10 |