Engine cooling system - check fluid level, adjust to correct level. Inspect anticorrosion/antifreeze protection, adjust to correct concentration - AP20.00-P-2010Z

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

MODEL 203.004 /006 /016 /018 /020 /035 /040 /042 /043 /045 /046 /061 /064 /065 /076 /081 /084 /204 /206/216 /218 /220 /235 /240 /242 /243 /245 /246 /261 /264 /265 /276 /281 /284 /706 /718 /730 /735 /740 /742 /743 /745 /746 /747 /764

MODEL 211.004 /006 /007 /008 /016 /020 /022 /023 /026 /028 /029 /041 /042 /052 /054 /056 /061 /065 /070 /072 /076 /077 /080 /082 /083 /084 /087 /089 /090 /092 /206 /208 /216 /220 /222 /223 /226 /241 /242 /254 /256 /261 /265 /270 /272 /276 /277 /280 /282 /283 /284 /287 /289 /290 /292 /606 /608 /616 /620

MODEL 414

MODEL 209.308 /316 /320 /341 /342 /343 /354 /356 /361 /365 /375 /376 /420 /441 /442 /454 /456 /461 /465 /475 /476

MODEL 215 (except 215.376 /379)

MODEL 220 (except 220.176 /179)

MODEL 230 with ENGINES 112, 113

MODEL 124, 129, 140, 168, 170, 202, 208, 210

MODEL 209 with ENGINE 156.9

	Check
	Risk of injury to skin and eyes caused by scalding from contact with hot coolant spray. Risk of poisoning caused by swallowing coolant.	Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses.	AS20.00-Z-0001-01A
	Notes on coolant		AH20.00-N-2080-01A
1	Remove screw cap of coolant expansion reservoir
2	Check coolant level	Coolant cold: Engine coolant level up to marking "Cold water level". Coolant warm: Engine coolant level approx. 1 cm above marking "Cold water level".
3	Inspect cooling system for leaks	If loss of fluid is not due to normal consumption (against separate order)
		Engine 103	ra20001020017x
		Engine 119	ra20001190170x
	Inspect cooling system for leaks	Engine 111 in model 203 Engine 112 except 112.912/916/946/947/953/955/960/961, Engine 113 except 113.963/968/987/988/990/991/992/995	AR20.00-P-1010HA
		Engine 120, 137, 601, 602, 603, 604, 605, 606, 613, 628, 646 except 646.8, 647, 648, Engine 611 except in model 203 Engine 612 except in model 203,
		Engine 156 in model 209, 211	AR20.00-P-1010TMG
		Engine 272, 273 in model 211	AR20.00-P-1010TS
		Engine 642 in model 211	AR20.00-P-1010TI
		Engine 629 in model 211	AR20.00-P-1010TJ
		Engine 113.963/990/991/992/995 Engine 112.960 in model 170.466 Engine 112.961 in model 203.065/265	AR20.00-P-1010RVK
		Engine 111, 112, 113, 271, 611, 612, 646 in model 203 Engines 271, 646.8 in model 211 Engine 112 in Model 170 Engine 112, 113, 271, 612 in MODEL 209	AR20.00-P-1010P
		Engine 642 in model 209	AR20.00-P-1010PI
		Engine 272 in model 209	AR20.00-P-1010QB
		Engine 166, 668 in model 168	AR20.00-P-1010GF
		Engine 166, 668 in model 414	AR20.00-L-1010VA
4	Inspect anticorrosion and antifreeze agent in coolant and coolant composition	Use only approved anticorrosion and antifreeze agents. If the coolant composition is incorrect: Correct the coolant composition (subject to separate repair order).
5	Mount screw cap for coolant expansion reservoir