Connect STAR DIAGNOSIS and read out fault memory - AD00.00-P-2000-04A

WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.

Illustrated on model 210

Fig 1: Connecting Star Diagnosis To Data Link Connector - Illustrated On Model 210

G05437981

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Illustrated on model 163

Fig 2: Connecting Star Diagnosis To Data Link Connector - Illustrated On Model 163

G05437982

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Shown on model 164.1

Fig 3: Connecting Star Diagnosis To Data Link Connector - Illustrated On Model 164.1

G05437983

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Shown on model 461.302

Fig 4: Connecting Star Diagnosis To Data Link Connector - Illustrated On Model 461.302

G05437984

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Illustrated on model 171.4

Fig 5: Connecting Star Diagnosis To Data Link Connector - Illustrated On Model 171.4

G05437985

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Connect STAR DIAGNOSIS (0100) to diagnostic socket, on the data link connector (X11/4) or on the data link connector (1.3) (X11/22).
Switch on ignition.
Start the Diagnosis Assistance System.
In the "Model" menu, select the sub menu "Other model series".
Go through the instructions on the screen:
- Enter the control unit version.
- Read fault memory, erase.
- Read actual values.
- Perform actuations.
- Adaptation of control units
Disconnect STAR DIAGNOSIS (0100).

Stored faults which may be caused by disconnecting cables or by simulation during testing operations must be deleted in the diagnostic trouble code memory following completion of the operations.