Wheel Carrier: Installation
WARNING: This page is about a different car, the 1994 Mercedes-Benz E500, 1994 Mercedes-Benz E420, and 1994 Mercedes-Benz E320. However, it is still accessible from the selected car via links, so may be relevant.
To install, reverse removal procedure. Using a jack, lift wheel carrier until rear axle shaft is horizontal. Axle shaft must be horizontal before tightening suspension nuts. See TORQUE SPECIFICATIONS. Perform 4-wheel alignment to adjust toe-in of rear wheels (if required). See WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT section.