Removing and installing starter - AR15.30-P-7100EA

ENGINE 111.920 /921 in MODEL 202.018 /078

ENGINE 111.941 /945 in MODEL 202.020 /080

ENGINE 111.961 in MODEL 202.022

ENGINE 111.974 in MODEL 202.023 /083

ENGINE 111.975 in MODEL 202.024 /085

ENGINE 111.944 in MODEL 202.025 /082

ENGINE 104.941 in MODEL 202.028

ENGINE 111.945 in MODEL 208.335 /435

ENGINE 111.944 in MODEL 208.345 /445

ENGINE 111.975 in MODEL 208.347 /447

Fig 1: Identifying Starter Remove/Install Components - Model 202, 208

MODIFICATION NOTES

6.7.00

Figure modified from 42 Nm to 58 Nm

Figure in BA15.30-P-1003-01A for engine 119 modified

	Removing, installing
	Risk of explosion from explosive gas. Risk of poisoning and caustic burns from swallowing battery electrolyte. Risk of injury from caustic burns to eyes and skin from battery electrolyte or from handling damaged lead acid batteries.	No fire, sparks, naked flames or smoking. Wear acid-protective gloves, clothing and eye protection. Pour battery electrolyte only into suitable and appropriately marked containers.	AS54.10-Z-0001-01A
1	Disconnect ground cable of battery		AR54.10-P-0003A
	Notes on battery	All models	AH54.10-P-0001-01A
2	Remove bottom engine compartment panel	Engine 104, 111 fitted with AC (code 580) in model 202.	AR61.20-P-1105A
		Model 202, 208	AR61.20-P-1105AB
3	Disconnect electric cables (1, 2)		*BA15.30-P-1001-01A
			*BA15.30-P-1002-01A
4	Remove bracket (6)
5.1	Remove brackets (4, 5 and 7)	Model 202
6.1	Unbolt rear engine mount at frame	Engine 104 with automatic transmission in model 202
7	Unscrew screws (3		*BA15.30-P-1003-01A
8	Take starter (M1) down and out	Engine 104 in model 202: turn steering slightly to the left.
9	Install in the reverse order
10	Carry out operational check
11	Make electrical system operational	Perform basic programming.	AR00.19-P-0200C

STARTER