Remove starter, install - AR15.30-P-7100GV

ENGINE 113.962 in MODEL 463.206 /240 /241 /247 /248 /249 /254 

ENGINE 113.982 in MODEL 463.243 /246 

Fig 1: Identifying Starter Remove/Install Components - Engine 113.962 In Model 463.206 /240 /241 /247 /248 /249 /254, Engine 113.982 In Model 463.243 /246

	Remove/Install
	Risk of explosion  from hydrogen gas. Risk of poisoning and caustic burns  from swallowing battery electrolyte. Risk of injury  to eyes and skin suffering caustic burns from battery electrolyte or from contact with damaged lead acid batteries.	No fire, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and glasses. Pour battery electrolyte only into suitable and appropriately marked containers.	AS54.10-Z-0001-01A
1	Disconnect ground line of battery	Installation:  Code radio, clock and adjust stationary heater timer if necessary.
		All Models except 463.241/248 with code 979	AR54.10-P-0003G
		Model 463.241 with code 979	AR54.10-P-0003PV
		Model 463.248 with code 979	AR54.10-P-0003PM
	Notes on battery	Model all	AH54.10-P-0001-01A
2	Disconnect electrical wires (2/3).		*BA15.30-P-1001-01A
			*BA15.30-P-1002-01A
3	Unscrew screws (1)		*BA15.30-P-1003-01A
			Figure
4	Take out starter (M1)
5	Install in the reverse order
6	Read diagnostic trouble code memory and erase	Read out fault memory with hand-held tester (HHT) and erase
	Connect STAR DIAGNOSIS and read out fault memory	STAR DIAGNOSIS Stored faults which may be caused by disconnecting cables or by simulation during removal and installation or inspection work, must be processed and erased in the fault memories after completing the work.	AD00.00-P-2000-04A
			*WH58.30-Z-1048-13A

STARTER

Fig 2: Identifying External Torx Set (001 589 76 09 00)