Remove starter, install - AR15.30-P-7100ED

ENGINE 112.910 in MODEL 202.026 /086

ENGINE 112.920 in MODEL 202.029 /089

ENGINE 112.915 in MODEL 202.088

ENGINE 112.940 in MODEL 208.365 /465

ENGINE 113.943 in MODEL 208.370 /470

ENGINE 113.984 in MODEL 208.374

Fig 1: Identifying Starter Remove/Install Components - Model 202, 208

MODIFICATION NOTES

6.7.00	Value changed from 16 Nm to 14 Nm	Figure in BA15.30-P-1001-01A for engine 112, 113 modified	*BA15.30-P-1001-01A
6.7.00	Value changed from 10 Nm to 6 Nm	Figure in BA15.30-P-1002-01A for engine 112, 113 modified	*BA15.30-P-1002-01A
6.7.00	Value changed from 58 Nm to 42 Nm	Figure in BA15.30-P-1003-01A for engine 112, 113 modified	*BA15.30-P-1003-01A

	Remove/Install
	Risk of explosion caused by oxyhydrogen gas. Risk of poisoning and caustic burns caused by swallowing battery acid. Risk of injury caused by burns to skin and eyes from battery acid or when handling damaged lead-acid batteries	No fire, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and glasses. Pour battery acid only into suitable and appropriately marked containers.	AS54.10-Z-0001-01A
1	Disconnect ground line from battery	Insulate clamping device of the ground line in order to prevent inadvertent contact with the ground point of the battery.	AR54.10-P-0003A
	Notes on battery		AH54.10-P-0001-01A
2	Remove lower engine compartment paneling		AR61.20-P-1105AB
3	Remove right engine mount	Engine 112.915
		Engine 112 except engine 112.915	AR22.10-P-1100AV
		Engine 113	AR22.10-P-1100MV
4	Dismount electrical lines (1, 2), to do this, unscrew bolts (4)	Nut, terminal 30 connection	*BA15.30-P-1001-01A
		Nut of connection circuit50	*BA15.30-P-1002-01A
5	Remove screws (3)		*BA15.30-P-1003-01A
6	Take starter (M1) down and out
7	Install in the reverse order
8	Perform function check
9	Render electrical system operational	Perform basic programming	AR00.19-P-0200C

STARTER