LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1994 >> C220 >> Repair and Diagnosis >> Drivelines & Axles >> Driveshaft & Universal Joints >> Propeller Shaft -- 202 Chassis >> Testing & Repair >> Pressing grooved ball bearing out and in at rubber mount of propeller shaft - AR41.10-P-0100-02DA

Pressing grooved ball bearing out and in at rubber mount of propeller shaft - AR41.10-P-0100-02DA

Fig 1: Identifying Removal And Installation Tool (116 589 09 43 00)
G04715566
Fig 2: Identifying Removal And Installation Tool (201 589 09 43 00)
G04715567

    Press out grooved ball bearing 

  1. Using the press out/in (tool 04), pry the grooved ball bearing (8) SPECIAL TOOL out of the rubber mount (7).

    SPECIAL TOOL 116 589 09 43 00 use with grooved ball bearing inside dia. of 30 mm.

    SPECIAL TOOL 201 589 09 43 00 use with grooved ball bearing inside dia. of 25mm.

    Fig 3: Pressing Grooved Ball Bearing Out And In At Rubber Mount Of Propeller Shaft
    G04715568

    2. Press in grooved ball bearing 

  2. Press grooved ball bearing (8) into the rubberized bearing seat up to the contact surface (arrows) using SPECIAL TOOL removal tool and press-in tool (04).

    IMPORTANT Ensure that the grooved ball bearing (8) is properly seated.

    Fig 4: Locating Contact Surface And Grooved Ball Bearing
    G04715569
scientia non olet · About LEMON Manuals