Removing and installing wiper linkage - AR82.30-P-7600E

MODEL 202, 208, 210 

Fig 1: Identifying Wiper Linkage Components - Model 202, 208, 210

	Removal
1	Remove ignition key
2	Remove wiper arm		AR82.30-P-6100E
3	Open engine hood, raise to vertical position	Model 202	AR88.40-P-1000E
		Model 208	AR88.40-P-1000F
		Model 210	AR88.40-P-1000F
4	Remove air inlet	Model 202, 208	AR83.25-P-1401E
		Model 210 left	AR83.25-P-1403F
		Model 210 right	AR83.25-P-1404F
5	Remove wiper system	Model 202, 208	AR82.30-P-6400E
		Model 210	AR82.30-P-6400F
6	Adjust basic setting of wiper gear head		AR82.30-P-6800-02E
7	Unscrew nut of wiper gear head shaft (1)
8	Press off crank arm of wiper gear head (2)
9	Unscrew wiper motor shaft nut
10	Press wiper linkage (3) off crank arm of wiper motor (4)
11	Take off wiper linkage (3)
	Installation
12	Move wiper motor into parking position		AR82.30-P-6800-01E
13	Fit on wiper linkage (3)
14	Press wiper linkage (3) onto crank arm of wiper motor (4)
15	Screw on wiper motor shaft nut		*BA82.30-P-1002-01A
16	Basic setting of wiper gear head		AR82.30-P-6800-02E
17	Press crank arm (2) onto shaft of wiper gear head	Pay attention to setting: crank arm of wiper motor (4) and wiper linkage (3) must be installed in extended position
18	Screw nut onto shaft of wiper gear head (1)		*BA82.30-P-1003-01A
19	Install wiper system	Model 202, 208	AR82.30-P-6400E
		Model 210	AR82.30-P-6400F
20	Install wiper arm		AR82.30-P-6100E
21	Install air inlet	Model 202, 208	AR83.25-P-1401E
		Model 210 left	AR83.25-P-1403F
		Model 210 right	AR83.25-P-1404F
22	Close engine hood	Model 202	AR88.40-P-1000E
		Model 208	AR88.40-P-1000F
		Model 210	AR88.40-P-1000F

Wiper

Number	Designation		Model 202	Model 208	Model 210
BA82.30-P-1002-01A	Wiper motor shaft nut	Nm	19	19	19
BA82.30-P-1003-01A	Nut of wiper gear head shaft	Nm	19	19	19