Removing and installing transmitter-receiver unit - AR82.70-P-8911A

MODEL 202.07 /08 /18 with CODE (274) MB D-network telephone 

MODEL 202.07 /08 /18, 210.2 with CODE (314a) D-network "Standard" telephone 

Model 202 T-model shown 

Fig 1: Identifying Transmitter-Receiver Unit Components - Model 202 T-Model Shown

Model 210 T-model shown 

Fig 2: Identifying Transmitter-Receiver Unit Components - Model 210 T-Model Shown

	Removing, installing
1	Connect quiescent current preservation unit		*WH58.30-Z-1012-09A
2.1	Remove battery	Model 202 T-model	AR54.10-P-0005EA
2.2	Disconnect ground cable at battery	To protect against inadvertent contact of disconnected ground cable with ground (battery) W10, insulate cable shoe of ground cable	AR54.10-P-0003A
3.1	Open side trim in right rear	Model 210 T-model
3.2	Remove side trim in right rear	Model 202 T-model	AR68.30-P-4780A
4	Unscrew screws (2)	Model 202 T-model
5	Unscrew nut (5)
6	Carefully lift bracket (1) with control modules out off wheel house recess	Do not damage connecting cables
7	Release and remove coupling on CTEL transmitter-receiver (A35)
8	Disconnect antenna cable on CTEL transmitter receiver (A35)
9	Loosen sheet-metal screw (3)
10	Remove CTEL transmitter-receiver (A35) upwards
11	Install in reverse order