Removing and installing wiper linkage - AR82.30-P-7600A

MODEL 129 

Fig 1: Identifying Wiper Linkage Components

	Removal
1	Remove wiper motor	Do not unscrew screws (8).	AR82.30-P-6800B
2	Adjust basic setting for wiper gear head		AR82.30-P-6800-02E
3	Unscrew nut (9) from wiper shaft
4	Press off linkage (10)
	Installation
5	Move motor to non-actuated state	Connect wiper motor to wiring harness and allow to run to parking position
6	Install crank arm (7) on wiper motor shaft	Install crank arm on wiper motor shaft and install nut (6). Linkage (A) should be positioned vertically above center of wiper motor shaft	*BA82.30-P-1002-01E
7	Adjust basic setting for wiper gear head		AR82.30-P-6800-02E
8	Install linkage (10) on wiper shaft	Install linkage (10) on wiper shaft and tighten nut (9).	*BA82.30-P-1003-01E
9	Install wiper motor	As of step 17.	AR82.30-P-6800B

WINDSHIELD WIPER

Number	Designation		Model 129
BA82.30-P-1002-01E	Nut on wiper motor shaft	Nm	19
BA82.30-P-1003-01E	Nut for wiper gear head shaft	Nm	29