Removing and installing rear axle headlamp range adjustment sensor - AR82.10-P-4084B

MODEL 129 

Fig 1: Identifying Rear Axle Headlamp Range Adjustment Sensor

	Removing, installing
1	Unhook connection linkage (2) from rear axle sensor (A51)
2	Disconnect connector (1) from rear axle sensor (A51)
3	Unscrew screws (3) and remove rear axle sensor (A51)
4	Install in the reverse order
5	Set zero position of xenon headlamps with HHT	See Diagnosis Manual, Body
6	Check and correct headlamp adjustment		AP82.10-P-8260A