Wheel Carrier: Installation

To install, reverse removal procedure. Using a jack, lift wheel carrier until rear axle shaft is horizontal. Axle shaft must be horizontal before tightening suspension nuts. See TORQUE SPECIFICATIONS. Perform 4-wheel alignment to adjust toe-in of rear wheels (if required). See appropriate SPECIFICATIONS & PROCEDURES article in WHEEL ALIGNMENT section below.

• WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES (for 190E)
• WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES (for 300D & 300E)
• WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES (for 400E)
• WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES (for 500E)