LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1993 >> 400E >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Air Bag Restraint System) >> Diagnosis & Testing >> SRS Self-Diagnostic Check (All Other Models) >> Retrieving Fault Codes: SRS Warning Light

Retrieving Fault Codes: SRS Warning Light

WARNING: This page is about a different car, the 1993 Mercedes-Benz 500SEL and 1993 Mercedes-Benz 500E. However, it is still accessible from the selected car via links, so may be relevant.
  1. Locate diagnostic connector. See ON-BOARD DIAGNOSTIC CONNECTOR LOCATION  table. See Figure -4. Turn ignition switch to ON position.
  2. Connect jumper wire between terminals No. 1 and 6 of on-board diagnostic connector for exactly 3 seconds, and remove jumper wire. If these 2 terminals are connected for 6 seconds or longer, fault code to be displayed will be erased.
  3. Jumping these 2 terminals will start SRS control unit self-diagnostics. SRS warning light will flash only SRS fault codes stored in memory. Observe and record all code numbers until first code number repeats. See appropriate SRS FAULT CODES  table.
scientia non olet · About LEMON Manuals