Removing and installing rear rubber mounts of rear axle mounting - AR35.10-P-0040-03E

Fig 1: Identifying Removal/Installation Tool (201 589 11 43 00)

Removing rubber mount 

1. Press rubber mount (1b) out of rear axle carrier (1) using removal tool (01a-01c).
   Fig 2: Identifying Rubber Mount, Rear Axle Carrier And Removal Tool (01A-01C)

   

   Installing of rubber mount 

2. Smear periphery of rubber mount (1b) with lubricant.
3. Draw in rubber mount (1a) using installation tool (01c, 01f, 01g).

   

   Position lower part of installation tool (01g) on rubber mount (1b) so that the lugs are not damaged during installation.

   Fig 3: Identifying Rubber Mount And Installation Tool (01C, 01F, 01G)