Hydraulic Test Program - Test Soft Top Up (Section 34): Notes

WARNING: Injury hazard from pinching and crushing, in extreme cases extremities can even be severed when caught in the mechanism. DO NOT allow any body parts to be in the general area of the moving components. DO NOT reach into the moving mechanism at any time during any tests. Keep away from the moving mechanism of components which are being activated using the Hand Held Tester (HHT) and or directly via circuit 30. Ensure that all test cables are of sufficient length.

NOTE: Prior to performing any of the following HYDRAULIC DIAGNOSTIC TESTS on the soft top. Review function test. See SOFT/HARD TOP SYSTEM - FUNCTION TEST (SECTION 11/1) under TROUBLE SHOOTING.

NOTE: During procedures the numbers in parentheses, within steps, correspond to numbers inside the illustration(s). The word arrow(s) in parentheses, within steps, is used to point out specific components or movement.