Removing and installing firewall pivot point with accelerator pedal lever - AR30.12-P-3022D

MODEL 124, 129, 140, 202, 461, 463 (except, 463.244 /245 /247 /248 /249 /250 /254 /309 /322 /323 /332 /333) 

MODEL 124, 463, 461 

Shown on model 124 

Fig 1: Identifying Firewall Pivot Point With Accelerator Pedal Lever - Model 124, 463, 461

MODEL 129, 140, 202 

Fig 2: Identifying Firewall Pivot Point With Accelerator Pedal Lever - Model 129, 140, 202

	Removing, installing
1	Remove/install accelerator pedal		AR30.12-P-1321D
2	Remove firewall pivot point (34) together with accelerator pedal lever (33)
3	Pull firewall pivot point (34) off accelerator pedal lever (33)	By pulling off the retainer (34/1) On models 140, 463, 461, only use the locking ring (34/3).
	Retainer for accelerator pedal lever modified	Model 140	BT30.12-P-0001-01A
4	Install in the reverse order	The locking pin (arrow) for the firewall pivot point (34) must engage in the bore in the firewall
	Checking
5	Check and adjust throttle control linkage	Engines 111, 104	AR30.10-P-1010D
		Engine 119.97 with ASR code 471a	AR30.10-P-1010EA
		Engine 119.97 without ASR code 471a	AR30.10-P-1010EB
		Engine 119.98	AR30.10-P-1010EC
		Engine 120.980/81	AR30.10-P-1010F
		Engine 120.982/83, engine 606.964	AR30.10-P-1010FA
		Engine 602.983 in model 461	AR30.10-P-1010GG
		Engines 604.910, 605.910/960 in model 202 with automatic transmission 722.4	AR30.10-P-1010HB
		Engine 605.910/960 with manual transmission 717.4 Engines 605.910/960, 606.961 with automatic transmission 722.6	AR30.10-P-1010HC