Pressing out and drawing in rear axle shaft at rear axle shaft flange - AR35.30-P-0115-03A

Fig 1: Identifying Extraction And Installation Tool (210 589 03 43 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Removal:

Cut the thread M8 (models 129, 140, 202 as of 08/93, 210 with core hole bore).
Use removal and insertion tool to press firmly attached rear axle shaft out of the rear axle shaft flange.

Fig 2: Identifying Insertion Tool And Rear Axle Shaft
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Installation

On rear axle shafts which are glued in before installation clean the splined shaft profile and rear axle shaft flange mechanically.
Pull in rear axle shaft using the extraction and insertion tool .

Fig 3: Pulling In Rear Axle Shaft Using The Extraction And Insertion Tool
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.