Removing and installing bulbs of headlamp unit - AR82.10-P-1201A

MODEL 129 except CODE (491) U.S. version except CODE (612b) Xenon headlamp unit 

Fig 1: Identifying Bulbs Of Headlamp Unit Components (1 Of 3)

	Removal, installation
1	Open engine hood, move to upright position	See Owner's Manual, model 129.
2	Remove windshield washer reservoir	Only required for right headlamp unit.
3	Open locking bow (1)
4	Take off housing cover (2)	Check seal for damage and wear and replace if necessary.
5	Disconnect electrical connector (3) from corresponding bulb
6	Open mounting clamp of corresponding bulb
N	Remove bulb	Do not touch bulbs with bare fingers. Use soft, grease-free rag. Observe correct installation position.
8	Install in opposite order
9	Perform function check