Remove/install steering idler arm, replacing plain rubber mount - AR46.40-P-0300A

MODEL 129 

Fig 1: Identifying Steering Idler Arm Components

	Remove, Install
Installation	Replace self-locking nuts
1	Detach tie rod (10) at steering idler arm (26)		AR46.40-P-0200A
2	Detach drag link (11) at steering idler arm (26)		AR46.40-P-0100A
3	Remove heat shield (26g)
4	Unscrew nut (26b), remove washer (26e). Pull out bolt (26a) and remove steering idler arm (26)		*BA46.40-P-1001-05A
5	Lift sealing lip at the slide bushing (26f) using a screwdriver and remove slide bushing from rubber mount
6	Use extractor (061) to pull out rubber friction bearing (26f)	Extractor Installation  : Use insertion tool to pull in rubber friction bearing as far as the stop	Fig 2
		Insertion tool	Fig 3
7	Install in the reverse order

STEERING IDLER ARM

Number	Designation		Model 129
BA46.40-P-1001-05A	Self-locking nut, steering idler arm to longitudinal frame member bearing bracket	NM	180

Fig 2: Identifying Puller (129 589 00 33 00)

Fig 3: Identifying Insertion Tool (115 589 08 61 00)