Removing and installing front seat head restraint motor - AR91.29-P-1432A

MODEL 129 

Fig 1: Identifying Front Seat Head Restraint Motor Components

	Removal, installation
1	Remove driver's seat cushion and backrest upholstery.		ra91001290055x
2	Remove paneling from rear of driver's backrest		ra91001290065x
3	Remove cable straps (1, 4)
4	Disconnect connector (2)
5	Remove mount (3) from backrest frame
6	Remove backrest adjustment drive shaft (5)	Pull drive shaft (5) out of gear. Do not actuate motor (7) so as not to change adjustment of backrest lock. Installation  : If backrest lock is adjusted incorrectly, ↓
		adjust backrest lock if necessary, only steps 14-18.	ra91001290125x
7	Remove motor (7)	Unscrew screws (arrows), press off spring clips (6) and remove motor (7) downward
8	Pull drive shaft (8) out of motor (7)
9	Install in the reverse order
10	Carry out operational check