Removal and installation of window molding at top of windshield - RA68001290425X(68-425)

Preliminary jobs:

Coupe roof removed (operating instructions).

Operation number of the operation texts and work units or standard texts and flat rates respectively 68

Fig 1: Identifying Window Molding At Top Of Windshield Components

Inside rear view mirror (1)	press off downward (disconnect electrical plug connector for memory, if present).
Screws (2, 3 each)	screw out.
Retaining plate (3)	remove.
Screws (4) 6 each	screw out.
Sun visors (5) and mounts (6, 2 each)	remove.
Light lenses (7, 2 each)	remove.
Screws (8, 2 each)	screw out.
Roof control unit (9)	disconnect from cross member (do not disconnect electrical plug connectors).
Window molding (10)	unhook in direction of arrow together with retaining clips (11), then unhook retaining clips (12). Observe installation note.

Press light lenses upward on inside and remove (arrow).

Fig 2: Locating Light Lenses

Installation note

Press retaining clips into window molding before installation.

Fig 3: Locating Retaining Clips Into Window Molding

Reveal molding with retaining clips (arrows).

First install window molding at side window molding.

Install in reverse order.

Fig 4: Locating Molding With Retaining Clips