LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1991 >> 350SD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Removal & Installation >> Instrument Cluster >> Installation

Instrument Cluster: Installation

  1. To install instrument cluster, reverse removal procedure. Install steering wheel as follows. DO NOT  lube slip ring contact surfaces on steering wheel. Position steering wheel onto shaft splines, and align reference marks made during removal. At the same time, align turn signal restoring cam on steering shaft with combination switch tang.
  2. Install steering wheel hub with extreme caution and ensure contact carbons are not broken. Install and tighten NEW steering wheel hub bolt to 60 ft. lbs. (80 N.m). Connect horn wiring.
  3. To install air bag module, reverse removal procedure. Tighten Torx screws to 53 INCH lbs. (6 N.m). Activate SRS, and perform system operation check to ensure system is functioning properly. See DISABLING & ACTIVATING AIR BAG SYSTEM and SYSTEM OPERATION CHECK in AIR BAGS article in this section.
scientia non olet · About LEMON Manuals