Exterior Light Failure Indicator Test
NOTE:
System uses a light monitoring control unit and a dash indicator light. When the bulb of an exterior light fails, dash indicator light is turned on.
NOTE:
When connecting any additional lighting equipment, ensure power connection is made to fuse circuit ahead of light monitoring control unit. This will avoid malfunction or damage to control unit
- Turn ignition switch to "2" position. Indicator light should glow. Light should go out when engine is started. When light is brightly lit, a light failure is indicated.
- If light remains lit until ignition switch is returned to "0" or "1" position, a brake light or turn signal light has failed. These circuits are connected to a memory circuit.
- With exception of brake lights and turn signals, indicator light will light when any circuit with a failed bulb is in use. Since most circuits have multiple bulbs, a visual check is necessary to determine failed bulb location.