Removing and installing bulbs of headlamp unit - AR82.10-P-1201E

MODEL 129 up to 30.5.98 with CODE (491) USA version

Fig 1: Identifying Bulbs Of Headlamp Unit Components (3 Of 3)

OPERATION NO. OF OPERATION TEXTS OR OF STANDARD TEXTS AND FLAT RATES

Operation no.

Operation text

	Removal, installation
1	Open engine hood. Move to upright position
2.1	Remove windshield washer water reservoir	Only required for right headlamp unit.
3	Remove housing cover (1)
4	Disconnect electrical connector (2) from bulb (4)
5	Remove mounting ring (3)
6	Remove bulb (4)	Do not touch bulbs with bare fingers. Use soft, grease-free rag. Observe correct installation position. Check sealing ring (5) for damage and wear, replace if required.
7	Install in opposite order
8	Check function