Removing and installing RF antenna lead - AR82.62-P-8221A

MODEL 129 

Fig 1: Identifying RF Antenna Lead

	Removal, installation
1	Remove radio		AR82.60-P-7502A
2	Remove paneling in trunk on left
3	Remove side wall in rear compartment		ra68001290455x
4	Remove driver-side door sill molding
5	Move driver's seat completely toward rear
6	Loosen carpeting in left footwell and fold back	Loosen carpeting in area of center console on left and fold back until wiring ducts (1, 2) are exposed.
7	Open driver-side wiring duct (3)
8	Open left rear compartment wiring duct (4)
9.1	Loosen RF antenna lead (5) from antenna (M11) and remove	Vehicles without foamed interior wiring harness Connect pull lead to antenna lead and pull through Wiring ducts (1, 2) cannot be opened
9.2	Loosen RF antenna lead (5) from antenna (M11)	Vehicles with foamed interior wiring harness.
10.1	Expose RF antenna lead (5) and separate from foam element	Vehicles with foamed interior wiring harness. Installation  : Route antenna lead in empty conduit and fasten.
11	Install in the reverse order