Removing and installing drive for horizontal seat adjustment - AR91.29-P-1300A

MODEL 129 

Fig 1: Identifying Horizontal Seat Components

	Removal, installation
1	Remove driver's seat cushion		ra91001290055x
2	Remove cover above cable duct	Unscrew screws (1) and remove cover.
3	Expose leads and disconnect connector from connector strip	Open cable straps on motor (4) and seat frame and remove clips from cover plate (2).
4	Remove cover plate (2) from gear (3)	Installation  : Replace self-locking nuts.
5	Unscrew screws (arrows) from motor (4)
6	Remove plastic bracket (5) over rubber lip
7	Remove motor (4)	Unhook flexible drive shafts and remove motor Installation  : Turn both threaded spindles for longitudinal adjustment (arrow) toward rear on stop.
8	Install in the reverse order
9	Carry out operational check