Removing and installing control module box - AR54.20-P-1257CS
MODEL 129 as of 1.9.95
OPERATION NO. OF OPERATION TEXTS OR STANDARD TEXTS AND FLAT RATES
| Op. no. | Operation text |
| Removing, installing | |||
| 1 | Remove control modules | AR54.15-P-1300CS | |
| 2 | Remove cover underneath right of instrument panel | ||
| 3 | Remove front passenger's airbag | ra9100129a680x | |
| 4 | Unscrew screws (2) | ||
| 5 | Remove data link connector (X11/4) | ||
| 6 | Remove screws (1) | ||
| 7 | Take out control module bracket (5) | ||
| 8 | Unclip coupling blocks (3) | ||
| 9 | Disconnect all connectors in housing of control module box (F23/1) | ||
| 10 | Pull off hose (6) on module box blower motor (M2/2) | ||
| 11 | Unclip connector on blower motor protective housing | ||
| 12 | Unclip connectors in the area of module box blower motor (M2/2) on housing of control module box (F23/1) | ||
| 13 | Disconnect electric connectors and connections in engine compartment and interior | ||
| 14 | Carefully guide disconnected cables and wiring harnesses out of control module box housing (F23/1) | ||
| 15 | Unscrew bolt (4) from base of housing of control module box (F23/1) | ||
| 16 | Unscrew bolts (7) in the area of the front passenger's airbag removed | ||
| 17 | Unscrew bolts (8) in front passenger's footwell. | ||
| 18 | Take out control module box housing | ||
| 19 | Detach blower motor (M2/2) | ||
| 20 | Install in reverse order |