Removing and installing receiver/amplifier control module - AR82.62-P-7721A

MODEL 129 

Fig 1: Identifying Receiver/Amplifier Control Module

	Removal, installation
1	Remove paneling in trunk on left
2	Connect quiescent current retention unit		*WH58.30-Z-1012-09A
3	Disconnect ground lead from battery		AR54.10-P-0003A
4	Remove receiver/amplifier (A2/3) with mount (4)	Unscrew nut (1), screw (2) and remove receiver/amplifier (A2/3) together with mount (4).
5	Remove receiver/amplifier (A2/3) from mount (4)	Unscrew screw (3) and remove receiver/amplifier (A2/3) out of mount (4)
6.1	Convert line-out unit (A2/1)	Code 810 Only when replacing receiver/amplifier (A2/3).
7	Install in the reverse sequence
8	Perform operational check

COMMERCIALLY AVAILABLE TOOLS

Number	Designation
WH58.30-Z-1012-09A	Quiescent current retention unit