Removal & Installation: Installation
WARNING: This page is about a different car, the 1984 Mercedes-Benz 190E and 1984 Mercedes-Benz 190D. However, it is still accessible from the selected car via links, so may be relevant.
- Apply grease to input shaft splines and bushing. Engage transmission in one gear and rotate it back and forth until input shaft and clutch disc splines align. Make sure to connect engine ground cable when installing transmission bolts.
- After connecting clutch slave cylinder, bleed hydraulic system. Using Crow's Foot (201 589 00 01 00), tighten drive shaft nut to 22-30 ft.lbs (30-41 N.m.). Reverse removal procedures to complete installation.