LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1990 >> 300CE >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Suspension - Rear >> Wheel Carrier R & I >> Removal

Wheel Carrier R & I: Removal

  1. Loosen rear axle shaft collar nut prior to lifting vehicle and removing wheel. Using Remover (201 589 00 61 00), remove rear axle shaft from axle shaft flange.
  2. Remove brake caliper and support flexible brake hose. Remove brake disc. Remove intermediate lever of parking brake and disengage cable control. Pull out lock on hand brake cable.
  3. Remove camber strut-to-wheel carrier bolt. Force clamping sleeve of strut out of wheel carrier. Remove pulling strut-to-wheel carrier bolt. Force clamping sleeve of pulling strut out of wheel carrier.
  4. Mark position of eccentric bolt of pulling strut in relation to axle carrier. Using Wrench (201 589 00 03 00), remove strut-to-axle carrier nut. Remove complete pulling strut.
  5. Remove track rod-to-wheel carrier nut. Using Puller (201 589 01 33 00) and Thrust Piece (201 589 05 63 00), force track rod from wheel carrier.
  6. Mark position of eccentic bolt of track rod in relation to axle carrier. Remove rod-to-axle carrier nut. Remove cam disk, eccentric bolt and complete track rod.
  7. Remove nut of pushing strut on wheel carrier and remove with washer, contour disk and bolt. Force clamping sleeve out of wheel carrier.
  8. Remove nut on spring link and remove from wheel carrier. Pull complete wheel carrier from rear axle shaft.
scientia non olet · About LEMON Manuals