Exterior Light Failure Indicator
The system uses a lamp monitoring control unit and a dash indicator light. When the bulb of an exterior light fails the dash indicator light is turned on.
NOTE:
When connecting any additional lighting equipment ensure the power connection is made to the fuse circuit ahead of the lamp monitoring control unit. This will avoid malfunction or damage to the control unit
- Turn ignition switch to "2" position. The indicator light should glow. Light should go out when engine is started. When the light is brightly lit a light failure is indicated.
- If the light remains lit, until the ignition switch is returned to the "0" or "1" position, a brake light or turn signal light has failed. These circuits are connected to a memory circuit.
- With the exception of the brake lights and turn signals, the indicator light will light when any circuit with a failed bulb is in use. Since most circuits have multiple bulbs, a visual check is necessary to determine failed bulb location.