Removal & Installation (190 SERIES)
- Disconnect negative battery cable. Remove cover under left side of instrument panel. Remove left instrument panel vent hose from below. Unscrew speedometer cable from below.
- Push instrument cluster out, (just a few inches), from rear. Instrument cluster is held in place by 5 spring clips located in the 2,4,8,10, and 12 O'clock positions. Alternatively, instrument cluster may be removed using the above steps, then pulling cluster out from the front using special hook tool (126 589 03 33 00), starting at the 10 O'clock position.
- Disconnect electrical connectors and oil line, (if equipped with manual oil pressure guage), and remove instrument cluster the rest of the way.
- To install instrument cluster, reverse removal procedure.