Removal & Installation (All Other Models)
Remove rubber sleeve on switch lever. Remove 2 screws and pull switch out slightly. Remove 2 horn wires. Remove lower instrument panel cover and unplug wiring to remove switch. To install, reverse removal procedure.
15 PIN CONNECTOR
| Pin No. & Destination | Wire Color | ||
|---|---|---|---|
| 1 Coolant Temp. Sensor | Green | ||
| 1 Push Button Switch | Green | ||
| 2 Fuel Gauge Transmitter | Blue/Black | ||
| 3 Low Fuel Light | Blue/Green | ||
| 4 Low Oil Indicator Switch | Brown/Black | ||
| 5 Bulb Failure Cntrl. Unit | Grey/Purple | ||
| 5 8-Pin Connector #1 | Grey/Purple | ||
| 6 High Beam Indicator | White | ||
| 7 Fuse Block, #15 (Unfused) | Pink/Black | ||
| 8 8-Pin Connector #8 (To #58b) | Gray/Blue | ||
| 9 Terminal Block #61 (Battery) | Blue | ||
| 9 Bulb Failure Cntrl. Unit | Blue | ||
| 10 Park Brake Indicator | Brown/White | ||
| 11 Brake Wear Indicator | Brown/Red | ||
| 12 Fuse No. 6, #15 | Black/Pink | ||
| 13 Low Coolant Indicator | Brown/Yellow | ||
| 14 Low Washer Fluid Indicator | Brown/Blue | ||
| 15 Oil Pressure Sensor | Brown/Green | ||
|
|||
8 PIN CONNECTOR
| No. & Destination | Wire Color |
|---|---|
| 1 15-Pin Connector #5 | Gray/Purple |
| 2 Radio Illumination | Gray/Purple |
| 3 Main Ground (W1) | Brown |
| 4 RH Turn Signal Indicator | Black/Green |
| 5 Starter Lock-Out / Elect. Speedo Sensor | White |
| 6 LH Turn Signal Indicator | Black/White |
| 7 Fuse No. 6, #15 | Black/Pink |
| 7 Tachometer | Black/Pink |
| 8 15-Pin Connector #8 | Gray/Blue |
| 8 Illum. Control Unit #58b | Gray/Blue |