Disc Brake Pads: Installation
- Using brass cylinder brush, clean disc pad guide surface in caliper. Siphon sufficient fluid from master cylinder reservoir to prevent overflowing. Press piston to bottom of bore.
- Install disc pads and wear sensor wires. Reverse removal procedure to complete installation. Check that dash light goes out. Reset pin in master cylinder if necessary.
- Using cylinder brush, clean disc pad guide surface in caliper. Siphon sufficient fluid from master cylinder reservoir to prevent overflowing. Press pistons to bottom of bores.
- Apply Molykote to back of disc brake pads. See Fig 1 . Install disc pads, cross spring and retaining pins.
- If equipped, install cover plate, retaining pin locking keys and wear sensor wires. Check that dash light goes out. Reset pin at master cylinder if necessary.