1986 Manual Transmission Removal - 190D & 190E: Installation

WARNING: This page is about a different car, the 1986 Mercedes-Benz 190E and 1986 Mercedes-Benz 190D. However, it is still accessible from the selected car via links, so may be relevant.

Place slave cylinder and line above transmission. Using an aligning tool, center clutch disc on flywheel. Install pressure plate. Tighten bolts 1 to 1 1/2 turns at a time until tight.
NOTE: When installing drive shaft to transmission, raise engine and transmission with jack. Tighten drive shaft center bearing clamp nut to 22-29 ft. lbs (30-39 N. m).
During installation, ensure clutch is fully seated in flywheel recess. To complete installation, reverse removal procedure. Bleed hydraulic system. Check clutch pedal and shift linkage adjustment.