Front Stabilizer Bar: Installation
- Position stabilizer bar in vehicle. Attach stabilizer clamping pieces on ends with sleeves flush to bar. Attach support of upper control arm to stabilizer bar, tightening large end bolt as far as possible.
- Install end covers to wheel wells. Position rubber bushings with splits rearward and install mounting brackets.
- Attach connecting rod toward level controller. Install regulating linkage, water hoses and pipes. Connect vacuum hoses, A/C hoses and oil pressure line.
- Install regulating valve for Climate Control (A/C) system. Install air cleaner, master cylinder and booster. Mount front wheels and lower vehicle to ground.
- Completely tighten stabilizer-to-control arm support bolts and bracket mounting bolts.
- Move suspension control switch to "NORMAL LEVEL" position. Recharge A/C system. Check and adjust vehicle level.