Clutch Pressure Plate &/Or Disc: Remove & Replace
WARNING: This page is about the 240D Automatic Trans, which is a different variant/trim than selected.
DOES NOT include resurface Flywheel.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 3.7 | C | |||
| Combination Procedure: CLUTCH HOUSING: Remove & Replace: | ||||
| 0.5 | B | |||
| Combination Procedure: CLUTCH SLAVE CYLINDER: Remove & Replace: | ||||
| 0.3 | C | |||
| Combination Procedure: FLYWHEEL: Remove & Replace: | ||||
| 0.3 | C | |||
| Combination Procedure: PILOT SHAFT BEARING: Remove & Replace: | ||||
| 0.4 | C | |||
| Combination Procedure: RELEASE BEARING SUPPORT TUBE: Remove & Replace: | ||||
| 0.8 | B | |||