Tel Antenna Inspection
NOTE:
- The integrity of the tel antenna cannot be determined from a single part. When inspecting the tel antenna, perform the following procedure.
- Connect the M-MDS to the DLC-2.
- Perform the DTC inspection for the telematics communication unit and verify if any DTCs related to the tel antenna is detected. (See DTC INSPECTION
.)
- If DTCs are detected, repair the malfunctioning location according to the applicable DTC troubleshooting. (Refer to the [DIAGNOSTIC ASSIST FUNCTION [DTC TABLE [TELEMATICS COMMUNICATION UNIT (TYPE-B)]] in the appropriate service information )