| Detection condition |
- The B2 brake temperature is the standard or more.
|
| Fail-safe |
- Limits engine torque.
- Inhibits manual mode.
|
| Possible cause |
- Oil cooler malfunction (adhesion of foreign matter) (Refer to [OIL COOLER REMOVAL/INSTALLATION
] in service information).
- Control valve body malfunction (ON/OFF solenoid valve No. 3 malfunction) (Refer to [CONTROL VALVE BODY REMOVAL/INSTALLATION
] in service information).
- Automatic transmission malfunction (automatic transmission internal malfunction) (Refer to [AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION
] in service information).
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Perform the following procedure to ensure that the DTC has been resolved:
- Switch the ignition to off to cool the vehicle.
- Drive the vehicle.
|
| System wiring diagram |
|