| Detection condition |
- Any one of the following conditions is met:
- The ATF temperature is the standard or more.
- The TCM board temperature is the standard or more.
- The B2 brake temperature is the standard or more.
Precondition
- Driving in manual shift mode or direct mode
|
| Fail-safe |
|
| Possible cause |
- Automatic transmission malfunction (Temperature in the automatic transmission reaches the standard or more and the system is protected). (Refer to [AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION
] in service information).
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Perform the following procedure to ensure that the DTC has been resolved:
- Switch the ignition to off to cool the vehicle.
- Drive the vehicle under the following conditions:
- Manual shift mode or direct mode
|
| System wiring diagram |
|