| Detection condition |
- The AT pressure sensor No. 6 detects abnormally high line pressure.
|
| Fail-safe |
- Inhibits learning control.
- Inhibits AAS.
|
| Possible cause |
- Automatic transmission malfunction (automatic transmission internal malfunction) (Refer to [AUTOMATIC TRANSMISSION REMOVAL/INSTALLATION
] in service information).
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Perform the following procedure to ensure that the DTC has been resolved:
- Drive the vehicle. (Use all gears from 1st to 8th gear)
|
| System wiring diagram |
|