| Detection condition |
- The AT pressure sensor No. 2 detects a malfunction in the sensor.
|
| Fail-safe |
- Inhibits learning control.
- Inhibits AAS.
|
| Possible cause |
- Control valve body malfunction (AT pressure sensor No. 2 malfunction) (Refer to [CONTROL VALVE BODY REMOVAL/INSTALLATION
] in service information).
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Perform the following procedure to ensure that the DTC has been resolved:
- Drive the vehicle. (Use all gears from 1st to 8th gear)
|
| System wiring diagram |
|