| Detection condition |
- Intermediate shaft speed signal is 12, 000 rpm or more.
Precondition
- Vehicle is being driven (not during shifting)
|
| Fail-safe |
- Inhibits learning control.
- Inhibits manual mode.
- Inhibits i-stop control. (Without Mazda M Hybrid boost)
- Inhibits AAS.
|
| Possible cause |
- DTC is stored in the TCM. (Sensor power supply No. 2 low voltage malfunction) (See P0652-00: ).
- Malfunction in the following control valve body component parts (Refer to [CONTROL VALVE BODY REMOVAL/INSTALLATION
] in service information).
- Intermediate shaft speed sensor
- Intermediate shaft speed sensor signal circuit
- Intermediate shaft speed sensor power supply circuit
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Perform the following procedure to ensure that the DTC has been resolved:
- Drive the vehicle under the following condition:
- Vehicle speed: 30 km/h {19 mph} or more
|
| System wiring diagram |
|