| Detection condition |
- The TCM detects an ON/OFF solenoid valve No. 3 circuit malfunction.
Precondition
- Battery voltage is the standard or more.
|
| Fail-safe |
- Inhibits learning control.
- If there is a short to power supply, inhibits driving (neutral).
- If there is a short to power supply, inhibits AAS mode.
|
| Possible cause |
- Malfunction in the following control valve body component parts (Refer to [CONTROL VALVE BODY REMOVAL/INSTALLATION
] in service information).
- ON/OFF solenoid valve No. 3 circuit (including connector/terminal) (open or short circuit)
- ON/OFF solenoid valve No. 3
- ON/OFF solenoid valve No. 1 circuit (including connector/terminal) (short to power supply)
- Shift solenoid No. 1 circuit (including connector/terminal) (short to power supply)
- Shift solenoid No. 2 circuit (including connector/terminal) (short to power supply)
- Shift solenoid No. 3 circuit (including connector/terminal) (short to power supply)
- Shift solenoid No. 4 circuit (including connector/terminal) (short to power supply)
- Shift solenoid No. 5 circuit (including connector/terminal) (short to power supply)
- TCM
|
| Repeatability verification procedure |
- Clear the DTC recorded in the memory. (See CLEARING DTC
.)
- Perform the following procedure to ensure that the DTC has been resolved:
- Drive the vehicle. (Use all gears from 1st to 8th gear and R position)
|
| System wiring diagram |
|